1.
Screw shim onto grub screw.
2. Place screw joint in engaging turn knob (rear side (1)).
3.
Check that screw joint (4) is positioned precisely in engaging turn knob.
4. Place nonwoven fabric (3) in engaging turn knob (rear side (1)).
5.
When installing engaging turn knob (5) make sure that position (6) is correct.
6.
Tighten bolt (7).
7.
Check that engaging turn knob can be turned to "push" position (clockwise) and "drive" position (counterclockwise).
1533060-N
Fig. 6-25
Fig. 6-26
Fig. 6-27
Fig. 6-28
Fig. 6-29
Service
39