Backrest; Replacing Easyadapt Back Unit; Replacing / Adjusting Universal Backrest Frame For Easyadapt - Invacare Storm 4 Series Service Manual

6.14 Backrest

6.14.1 Replacing EasyAdapt Back Unit

Tools:
• 5 mm Allen key
• Oblique pliers
• Cable ties
Removing Back Unit
1. Remove back cushion.
2. Pull actuator cable out of actuator module under seat.
3. Pull cable out of mobility device. Remove any cable
ties which are fitted.
4. Loosen and remove Allen screws (5) incl. washers on
left and right side of seat.
5. Carefully remove back section (1) together with
lower part (2) from seat support (3). Two parts are
interconnected via the arm (4).
Installing Back Unit
1. Refit parts in reverse order.
2. Test all functions.

6.14.2 Replacing / Adjusting Universal Backrest Frame for EasyAdapt

Tools:
• Measuring tape
• Adhesive tape
• 13 mm open-end wrench
• 4 mm Allen key
• 5 mm Allen key
• Phillips screwdriver, size 2
Removing Universal Backrest Frame
1. Remove backrest cushion.
2. Loosen and remove four Allen screws (1).
3. Remove universal backrest frame (2) from EasyAdapt
backrest.
1533060-N
Fig. 6-128
Fig. 6-129
Service
95