Invacare Storm 4 Series Service Manual page 70

Invacare® Storm⁴ Series
1. Remove rear and centre shroud. See 6.8.1 Replacing
Rear Shroud, page 55 and 6.8.2 Replacing Centre
Shroud, page 55.
2. In case of lifter cabling, also remove front shroud. See
6.8.3 Replacing Front Shroud, page 56.
3. Lead cables on power module and actuator module
fitted at rear through recess in battery flap under
actuator module to cable bridge (1).
4. Lead cables inside shrouds over cable bridge (1).
5. Fasten cables with cable clamps (2). Cable clamps on
front side of battery box for lifter cables (optional) are
not seen in picture.
6. Motor cables fitted with protection shrouds (2) are
guided out of front shroud through recesses on side.
7. Cables that lead to seat (upper actuator module,
remote, headlight) are guided out of front shroud
through an upper left recess (3).
8. Make sure cable has enough play so that all movable
parts can move freely without stretching, clamping or
abrading cable.
9. Lay cables in same way under seat and to remote.
Fasten cables with prescribed cable clamps or tie wraps
respectively.
Installing on Lifter Column Type B
If a type B lifter column is already installed, see Installing on Lifter Column Type B - Part 2 , page 73.
Installing on Lifter Column Type B - Part 1
• 4 mm Allen wrench
• Side cutting pliers
• Tie wraps
The cables leading from battery box to seat must be installed so they do not get crimped, stretched or sheared when
raising or lowering seat.
70
Fig. 6-65 Lifter column type B
Fig. 6-63
Fig. 6-64
1533060-N