Table of Contents
Advertisement
Invacare® Storm⁴ Series
Removing Centre Shroud
1. Remove rear shroud. See 6.8.1 Replacing Rear Shroud,
page 55.
2. If possible, use lifter to move seat to uppermost position.
3. Loosen two screws A.
4. Lift rear part of shroud carefully and remove two
spacers underneath shroud.
5. Lift off shroud. If mobility device does not have lifter,
shroud must be bent apart carefully as shown in picture.
Installing Centre Shroud
1. Install parts in reverse order.
2. Tighten screws finger-tight.
6.8.3 Replacing Front Shroud
•
4 mm Allen key
Removing Front Shroud
1. Use lifter to move seat to uppermost position. If no
lifter is installed, remove seat as described in or 6.12
Seating, page 87.
2. Remove rear and centre shroud. See 6.8.1 Replacing
Rear Shroud, page 55 and 6.8.2 Replacing Centre Shroud,
page 55.
3. Loosen two screws (1) – concealed by motor in picture.
4. Pull motor cable and guide bushes (2) out of lateral
recesses.
5. Pull connecting cable to seat out of recess (3).
6. Lift front shroud up so that retaining clips (4) are
exposed.
7. Pull shroud off towards front.
Installing Front Shroud
1. Install parts in reverse order.
2. Make sure that retaining clips (4) snap securely into
openings of shroud.
3. Tighten all screws finger-tight.
6.8.4 Replacing module shroud
•
Installation kit
•
Needlenose pliers
•
Flat screwdriver
Module shroud protects cables.
1. Remove both rivets B.
2. Remove module shroud A.
3. Install parts in reverse order.
56
Fig. 6-46
Fig. 6-47
1533060-N
Advertisement
Table of Contents
