Table of Contents
Advertisement
Installing Rear Light
1. Install all parts in reverse order.
2. Install cables carefully and secure them with cable
clamps and tie wraps.
3. Test all functions.
6.12 Seating
•
This manual refers to configurations with Easy Adapt and Recaro Seat unit only.
•
For seat systems, such as Modulite and Ultra Low Maxx, refer to the corresponding seat service manual.
•
4 mm Allen key
Before you get access to the seating components, you need to:
•
Remove legrests and armrests.
•
Easy Adapt seat only: Remove seat cushion.
•
Recaro seat only: Loosen and remove four screws on bottom side of seat. Remove seat.
•
Remove any existing tie wraps holding cables on remote or lighting. Remove cables from stuck-on clamps.
•
Loosen cap nuts of headlight mountings. See 6.11 Lighting Unit, page 76.
•
Put headlight and mounting in safe place on rear part of battery box.
•
Remove all cables between seat and chassis.
6.12.1 Replacing Seat Support Plates
Tools:
•
4 mm Allen key
Easy Adapt Seat
Removing Seat Support Plates
1. Remove cover plates (1).
2. Loosen and remove two Allen screws (7) which are
located on side at front of seat support plate.
3. Loosen and remove two Allen screws (8) which are
located on side at rear of seat support plate.
4. Loosen and remove two Allen screws (9) at front of
seat support plate.
5. Remove seat support plate (2).
6. Insert and tighten Allen screws (9) to seat frame (3)
and crossmember (4) so that crossmember cannot fall
out of seat frame.
7. Repeat operations on other side of seat.
Installing Seat Support Plates
1. Loosen and remove two Allen screws (9) from seat
frame (3) and crossmember (4).
2. Replace seat support plate (2).
3. Fit two Allen screws (9) at front of seat support plate
and tighten them one after another.
4. Fit two Allen screws (7) which are located at front of
seat support plate.
5. Fit two Allen screws (8) which are located at rear of
seat support plate.
6. Repeat operations on other side of seat.
7. Refit all parts you have removed.
8. Test all functions.
1533060-N
Fig. 6-112 Exploded drawing of seat support
Service
87
Advertisement
Table of Contents
