Table of Contents
Advertisement
Dismantling tilt module
1. If possible, use lifter to move seat to uppermost position.
2.
Carefully note the location of the cable and the connection locations of the various plugs. Either mark each plug
and socket, or take a photograph with a digital camera.
3. Pull plug (1) out of actuator module.
4. Remove the two Allen screws (2).
5. Replace actuator module.
Refitting tilt module
1. Refit parts in reverse order.
2. Plug all plugs into their old positions.
3. Check all mobility device functions.
6.9.7 Replacing Light Board
Replacement is described in the following section based on the example of a mobility device with an optional light board
and an optional actuator module.
•
4 mm Allen key
•
8 mm socket wrench
Removing Light Board
1. If possible, use lifter to move seat to uppermost position.
2. Remove rear and centre shroud. See 6.8.1 Replacing
Rear Shroud, page 55 and 6.8.2 Replacing Centre Shroud,
page 55.
3. Carefully note the location of the cable and the
connection locations of the various plugs. Either mark
each plug and socket, or take a photograph with a
digital camera.
4. Pull plug A out of light board.
5. Loosen and remove two screws C.
6. Lift off light board together with retaining bracket.
7. Loosen screws B and the corresponding nuts on the
rear.
8. Replace light board.
Installing Light Board
1. Install parts in reverse order.
2. Plug all plugs into their old positions.
3. Check all mobility device functions.
6.9.8 Replacing Lighting/Actuator Module CLAM
•
Phillips screwdriver size 2
•
3 mm Allen key
•
4 mm Allen key
•
8 mm socket wrench
1533060-N
Fig. 6-54
Service
63
Advertisement
Table of Contents
