Veeder-Root TLS-350 System Setup Manual page 22

3
Setup Mode Organization
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
FUNCTION
COMMUNICATION SETUP
STEP
STEP
STEP
STEP
STEP
STEP
FUNCTION
IN-TANK SETUP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
STEP
0.2 gph (0.76 lph) Line Test Auto-Confirm (Enable/Disable)
0.1 gph (0.38 lph) Line Test Auto-Confirm (Enable/Disable)
Daylight Savings Time (Disable/Enable)
HRM-QPLD Printouts (Enable/Disable)
Re-direct Local PrintouT (Enable/Disable)
Euro Protocol Prefix
Bdim Trans Alarm Delay
System Security Code
Maintenance History (Enable/Disable)
Tank Chart Security
Custom Alarms
Service Notice
Inventory Alarms Threshold Units (Standard, All % Full, All Volume, All Height, Custom)
System Beeper (Enable/Disable)
Mass/Density
Fiscal Height Security
Alarm Reduction (Enable/Disable)
Comm Board Port Settings - Repeat for each board (Baud Rate/Parity/Stop Bit/Data Length/
Dial Type/Answer On/Code/Modem Setup String/Dial Tone Interval/DTR Normal State
Auto Transmit Setup (Transmit Message Setup/Auto-Transmit Delay Time/Auto-Transmit Repeat
Time)
Phone Directory Setup
Auto Dial Setup
Auto Dial Alarm
RS-232 End Of Message
Tank Config Module 1 (Up To 3)
Product Label
Product Code
Thermal Coeff.
Tank Density
Tank Diameter
Tank Profile (1 Pt/4 Pts/20 Pts/linear/50 Pts)
Full Volume
Meter Data Present
Vapor Loss Factor
End Factor (None/Flat/Hemispherical/Other)
End Value
Calibration Update
Float Size
Water Minimum
Water Warning Limit (Not Active For Tanks With High Alcohol Probes)
High Water Limit (Not Active For Tanks With High Alcohol Probes)
Water Alarm Filter (Not Active For Tanks With High Alcohol Probes)
Max Or Label Volume
3-3
Setup Mode Programming Table