Table of Contents
Advertisement
Figure 4-7:
4.8
Main menu
To access the Main menu
(Figure
•
•
•
•
•
Quick Start Guide
Example of a Help Screen
(Figure
4-5) or the Pressure and Temperature screen
DIAGNOSTICS: Displays various parameters used in the internal calculations and
compares desired and actual parameters, for example, the analysis cell pressure and
temperature. The diagnostics routines and screens are used to perform fault
diagnosis.
FAULTS: Takes you to a screen that lists any faults affecting the analyzer. This option
is used as part of the failure diagnosis procedures.
GAS SERVICE: Allows you to check the sensor readings against a known gas source
(verification) or, if necessary, to calibrate the analyzer against that known gas source
(calibration).
DATA SERVICE: Takes you to a screen that allows data to be downloaded from the
instrument. The downloaded data is used to diagnose faults.
SYSTEM: Takes you to a screen that allows you to shut down the analyzer or access
system information, such as software versions or IP addresses. The main
motherboard IP address can also be changed from this menu. Some of these options
are not available on older analyzers.
4-8), press
on either the Gas Sensor Main screen
(Figure
Operating the analyzer
4-6). The Main menu options are:
41
Advertisement
Table of Contents
