Cut/Strip Postion Fine Adjustment - Toshiba B-570 Maintenance Manual

6. DIAG. TEST OPERATION
6.3.2 Cut/Strip Position Fine Adjustment
< 1 >
D I A G N O S T I C
< 2 >
P A R A M E T E R
Press the [PAUSE] key twice.
C U T A D J U S T
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds enables
a fast forward.
2. Max. fine adjustment 50.0 mm = Key fine adjustment value ( 50.0 mm) + PC fine
adjustment value (
When the value reaches the maximum, the value remains unchanged even if a
subsequent fine adjustment is performed.
3. A changed cut/strip position value is stored in memory by pressing the [PAUSE] key.
4. When using label with length of less than 38 mm, calculate the cut position fine
adjustment value using the expression provided on page 6-19.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [FEED] key.
S E T
Press the [FEED] or
[RESTART] key to adjust
the feed length.
(See NOTE 1.)
Press the [FEED] key
and [RESTART] key
at the same time.
V 1 . 0 A
+ 0 . 0 m m
[FEED] key:
[RESTART] key: Pressing the [RESTART] key one
Press the [PAUSE] key.
Continued on Section 6.3.3
Back feed length fine adjutment.
50.0 mm)
6-16
EM18-33010A
(Revision Date Jan. 13, '95)
6.3 PARAMETER SETTING MODE
Pressing the [FEED] key one time
is a -0.5 mm change, up to -50.0
mm. (See NOTE 2.)
time is a +0.5 mm change, up to
+50.0 mm. (See NOTE 2.)