Zero-Point Offsets - Siemens SINUMERIK 840D sl Operation/Programming Manual

08/2005
6
6.2

Zero-point offsets

Activating the zero-point
offset
ZPO
Selection
6.3 Simple workpiece machining in manual mode
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
As an alternative to the "Set ZPO" function (see Sec. "Setting the
zero-point offset"), you have the option of inputting the values of the
zero-point offset directly into the zero-point offsets list.
Select the "Work offset" softkey in the "Tools WOs" operating
section.
The work offset list appears.
Position the cursor on the desired zero-point offset.
Press the "ZPO selection" softkey
In "manual" mode, you can directly carry out simple machining
processes without having to write a program.
The following functions are available to you for machining in manual
mode:

Axle movements

Taper turning

Straight (face or longitudinal turning)
Tool, spindle speed, and direction of spindle rotation are activated by
"Cycle Start".
A change in feedrate immediately becomes active.
Working with Manual Machine
6.2 Zero-point offsets
6
6-335