Machining the Workpiece
3
3.7 Overstoring
Overstore without single
block
Cycle Stop
Cycle Start
Stopping overstore
Cycle Start
3-104
After "Overstore", a subroutine with the content REPOSA, which you
can observe, is executed.
Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
Press the "Cycle Stop" key.
Press the "Overstore" softkey.
The "Overstore" window is opened.
Enter the NC blocks to be processed.
Press the "Cycle Start" key.
The blocks you have entered are stored. You can observe execution
of the blocks in the "Overstore" window.
After the entered blocks have been executed, you can append blocks
again.
Press the "Back" key to exit "Overstore".
The window is closed.
You can switch modes now.
After you have pressed "Cycle Start" again, the selected program
continues before overstore.
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
3
© Siemens AG, 2005. All rights reserved