Siemens SINUMERIK 840D sl Operation/Programming Manual page 99

08/2005
3
3.5 Starting the machining at a specific point in the program
To External -
contour without cal.
...
Cycle Start
Cycle Start
Reset
Interrupt
point
To External -
contour without cal.
...
Cycle Start
Cycle Start
Reset
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
Press the "Block search" softkey.
Select a calculation technique.
Press the "Cycle Start" key.
ShopTurn carries out all necessary pre-settings.
Press the "Cycle Start" key again.
The new starting position is approached. The program executes from
the beginning or end of the target block, depending on the calculation
technique.
You can abort the search by pressing the "Reset" key.
Select point of interruption
Program execution must have been interrupted by pressing the
"Reset" key. (ShopTurn automatically remembers this point of
interruption.)
Switch back to "Machine Auto" mode.
Press the "Block search" and "Search pointer" softkeys.
Search
pointer
Press the "Interrupt point" softkey.
ShopTurn inserts the saved interrupt point as a target.
Select a calculation technique.
Press the "Cycle Start" key.
ShopTurn carries out all necessary pre-settings.
Press the "Cycle Start" key again.
The new starting position is approached. The program executes from
the beginning or end of the target block, depending on the calculation
technique.
You can abort the search by pressing the "Reset" key.
Machining the Workpiece
3
3-99