08/2005
9
9.2 Managing programs with ShopTurn on NCU (HMI Embedded)
9.2.5 Marking several programs
Selecting several
programs as a block
Mark
-or-
Selecting several
programs individually
-or-
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
You can select several programs individually or in a block for
subsequent copying, deleting, etc.
Open the Program Manager.
Place the cursor on the first program that you want to select.
Press the "Mark" softkey.
Expand the program selection area by pressing the cursor up or
down key.
The entire block of programs is marked.
Open the Program Manager.
Place the cursor on the first program that you want to select.
Press the "Select" key.
Move the cursor to the next program that you want to select.
Press the "Select" key again.
The individually selected programs are marked.
Program Management
9
9-381