Starting/Stopping Machining - Siemens SINUMERIK 840D sl Operation/Programming Manual

08/2005
3
Execute
Select program
(by program block)
-or-
-or-
-or-
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition

3.1 Starting/stopping machining

The program overview is displayed.
Place the cursor on the required program.
Press the "Execute" softkey.
ShopTurn automatically switches to "Machine Auto" mode and loads
the program.
Press the softkey or the "Program" key.
The directory overview is displayed.
Place the cursor on the directory containing the program that you
want to select.
Press the "Input" or "Cursor right" key.
The program overview is displayed.
Place the cursor on the required program.
Press the "Input" or "Cursor right" key.
The selected program is opened in the "Program" operating area. The
machining plan of the program is displayed.
Place the cursor on the program block at which the program run
must begin.
Press the "Execute" softkey.
ShopTurn automatically switches to "Machine Auto" mode, loads the
program and carries out a block search to the highlighted program
block (see Section "Starting at a Specific Point in the Program").
Machining the Workpiece
3
3-91