Siemens SINUMERIK 840D sl Operation/Programming Manual page 348

G Code Program
7
7.2 Executing a G-code program
G code program:
Execution
-or-
Execute
Cycle Start
7-348
Press the softkey or the "Program" key.
-and-
Position the cursor on the desired G code program.
-and-
Press the "Execute" softkey.
-or-
Press the "Execute" softkey if you are in the "Program" operating
area.
ShopTurn automatically switches to "Machine Auto" mode and loads
the G-code program.
Press the "Cycle Start" key.
Execution of the G code program starts on the machine.
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
7
♥ Siemens AG, 2005. All rights reserved