Sony Handycam DCR-TRV75E Operating Instructions Manual page 231

Changing the menu settings
Icon/item Mode
TAPE SET
REC MODE
z SP
AUDIO MODE z 12BIT
qREMAIN z AUTO
FRAME REC
z OFF
INT. REC
z OFF
Notes on the LP mode
•When you record the tape in the LP mode on your camcorder, we recommend playing back the tape
on your camcorder. When you play back the tape on other camcorders or VCRs, noise may occur in
pictures or sound.
•When you record in the LP mode, we recommend using a Sony Excellence/Master mini DV cassette
so that you can get the most out of your camcorder.
•You cannot make audio dubbing on the tape recorded in the LP mode. Use the SP mode for the tape
to be audio dubbed.
•When you record in the SP and LP modes on one tape or you record some scenes in the LP mode, the
playback picture may be distorted or the time code may not be written properly between scenes.
Notes on AUDIO MODE
•You cannot dub audio sound on the tape recorded in the 16-bit mode.
•When playing back the tape recorded in the 16-bit mode, you cannot adjust the balance in AUDIO
MIX.
Meaning
To record in the SP (Standard Play) mode
LP To increase the recording time to 1.5 times the SP mode
To record in the 12-bit mode (two stereo sounds)
16BIT To record in the 16-bit mode (the one stereo sound
with high quality)
To display the remaining tape:
• For about eight seconds after setting the POWER
switch to VCR or CAMERA and inserting a cassette,
then your camcorder calculates the remaining
amount of tape
• For about eight seconds after setting the POWER
switch to VCR and
ON To always display the remaining tape indicator
To deactivate frame recording
ON To activate frame recording (p. 84)
ON To activate Interval Recording (p. 82)
To deactivate Interval Recording
SET To set INTERVAL and REC TIME for Interval
Recording
is pressed
(continued on the following page)
POWER
switch
231