Step 1 Preparing the power supply
Charging the battery pack
Use the battery pack after charging it for your camcorder.
Your camcorder operates only with the "InfoLITHIUM" battery pack (F series).
See page 171 for details of the "InfoLITHIUM" battery pack.
(1) Open the jack cover and connect the AC power adaptor supplied with your
camcorder to the DC IN jack with the plug's v mark facing the lens side.
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to a wall outlet.
(4) Verify that the POWER switch is set to OFF (CHG).
The CHG lamp lights up when the charge begins. After the charge is
completed, the CHG lamp goes out (normal charge). To fully charge the
battery (full charge), leave the battery pack attached for about one hour after
normal charge is completed. Fully charging the battery allows you to use the
battery longer than usual.
2
After charging the battery pack
Disconnect the AC power adaptor from the DC IN jack on your camcorder.
Note
Prevent metallic objects from coming into contact with the metal parts of the DC plug of
the AC power adaptor. This may cause a short-circuit, damaging the AC power
adaptor.
4
POWER
CAMERA
MEMORY/
(CHG)
NETWORK
OFF
VCR
ON
MODE
1
CHG lamp
19