Inquiries; Operation - ABB PowerValue 31/11 T 10 kVA User Manual

Standards as reference:
• EN-IEC 62040-1. Uninterruptible power supply (UPS). Part 1-1: General and safety requirements for
UPS's used in accessible areas by end users.
• EN-IEC 60950-1. IT equipment. Safety. Part 1: General requirements.
• EN-IEC 62040-2. Uninterruptible power supply (UPS). Part 2: EMC requirements.
• EN-IEC 62040-3. Uninterruptible power systems (UPS). Part 3: Performance and test requirements
• 2011/65/EU Restriction of the use of certain hazardous substances (RoHS) DIRECTIVE
The supplier's responsibility is excluded in the event of any modification or intervention in the product by
the customer's side.
Safety
Electromagnetic Compatibility (EMC)
RoHS
1.4

Inquiries

Address inquiries about the UPS to the local office or agent authorized by the supplier. Please note the
type code and the serial number of the equipment and contact your nearest agent authorized by the
supplier. The serial number is shown in the nameplate of the product. For further information on
troubleshooting, go to Section 7.
1.5

Operation

- Do not remove the enclosure of the UPS. This system is to be serviced by qualified service
personnel only.
Earth connection is essential before connecting to the building-wiring terminal.
-
- Do not disconnect the mains cable from the UPS or the building wiring socket during operation as
this would remove the ground of the UPS and of all connected loads.
- An emergency switching device, which prevents further supply to the load by the UPS in any mode of
operation, should be provided in the building wiring installation.
- An appropriate disconnection device such as short-circuit backup protections should be provided in
the building wiring installation.
To disconnect completely the UPS, follow the instructions in Section 5.3.2.
-
- Indiscriminate operation of switches may cause output loss or damage to equipment.
- Ensure that no liquid or other foreign objects enter the UPS.
Product Standards
IEC/EN 62040-1
IEC/EN 62040-2 (C1)
EN50581:2012
Figure 1: Standards
4NWP100559R0001_OPM_ABB_PVA31-11-T_10-20kVA_EN_140626
Modifications reserved
Standards
IEC/EN 60950-1
IEC/EN 61000-4-2
IEC/EN 61000-4-3
IEC/EN 61000-4-4
IEC/EN 61000-4-5
IEC/EN 61000-4-6
IEC/EN 61000-4-8
IEC/EN 61000-2-2
EN50581:2012
Page 7/37 ABB