ABB PowerValue 31/11 T 10 kVA User Manual page 28

5.4.2.2 Measurements
To enter this menu, press
To navigate through the measurements, press
To return to the last menu (event log), press
5.4.2.3 Control
From this menu, the user can control some features of the UPS. The possible operations are indicated in
Table 5.
Control
Buzzer mute
Single UPS battery test
Parallel UPS battery test
Clear EPO status
Reset failure status
Clear event log
Restore factory settings
To modify the parameters, press
To confirm the selection, press
the control menu.
. In this menu, the following measurements are displayed:
Measurements
Output power [W]
Output power [VA]
Output current [A]
Load percentage [%]
Output voltage [V]
Output Freq. [Hz]
Input voltage [V]
Input Frequency [Hz]
Battery Voltage [V]
Battery Capacity [%]
DC Bus Voltage [V]
Temperature [
Table 4: Measurements menu information
for more than 1s.
Description
Mute the UPS sound
Initiate test of the batteries of a single UPS
Initiate test of the batteries of a group of UPSs
Remove UPS from emergency power off status
Reset warning and alarming status and buzzer
Reset all the events from the log file
Recover all settings in the LCD menu and the
EPO polarity and locks the DC start-up (can be
executed only when UPS is in bypass mode)
Table 5: Control menu parameters
for less than 1s. Then scroll up or down to modify the parameters.
for more than 1s.
4NWP100559R0001_OPM_ABB_PVA31-11-T_10-20kVA_EN_140626
Modifications reserved
o
C]
or .
gives an overview on how to navigate on
Figure 23
Possible Values
No/Yes
Schedule No/Yes
Seg1 and seg 2: on/off
No/Yes
No/Yes
No/Yes
No/Yes
Page 28/37 ABB
Default
Values
No
No
On / On
No
No
No
No