Operation; Control Panel; Leds - ABB PowerValue 31/11 T 10 kVA User Manual

5 OPERATION

This chapter describes how to operate the UPS through the LCD display.
WARNING!
The only user permitted operations are:
·
Operate the LCD display
·
Start up and shut down of the UPS of the user field (excluding the commissioning start up)
·
Operation of additional SNMP adapters and their software
5.1

Control Panel

The user-friendly control panel is composed of LEDs, an LCD display and four selection keys.
5.1.1

LEDs

The LEDs gives the UPS mode or a faulty situation at a glance. The LEDs may blink or stay constantly
on depending on the UPS status. Table 3 indicates the meaning of each LED.
UPS status
Bypass mode / no power in output
Bypass mode / powered output
UPS is turning ON
Online mode
Battery mode
ECO mode
Battery test mode
Fault mode
Warning
Legend:
A: LED flashing
B: constantly lightened
C: lightened circularly
D: depends on the failure/warning
ONLY PERSONS
TECHNICIANS OF THE SUPPLIER OR HIS AUTHORIZED SERVICE
PARTNERS ARE ALLOWED TO OPERATE THE CONTROL PANEL OF
THE UPS.
ALL OTHER INTERVENTIONS ON THE UPS SYSTEM HAVE TO BE
DONE ONLY BY SERVICE TECHNICIANS OF THE SUPPLIER.
Figure 18: Control Panel
LED Normal
(green)
-
-
C
B
B
B
C
-
D
Table 3: LEDs indication
4NWP100559R0001_OPM_ABB_PVA31-11-T_10-20kVA_EN_140626
Modifications reserved
WHICH HAVE BEEN
LED Battery
(yellow)
-
-
C
-
B
-
C
-
D
TRAINED BY SERVICE
LED Bypass LED Fault
(yellow) (red)
A D
B D
C C
- D
- D
B D
C C
D B
D A
Page 22/37 ABB