General Characteristics; Environmental Requirements; Ce Marking And Declaration Of Safety And Emc Conformity; Inquiries - ABB Conceptpower DPA 500 Operating Manual

General characteristics

2.1

Environmental requirements

To operate the UPS at the best efficiency point, your installation site should meet the environmental
parameters outlined in this manual. Excessive amount of dust or moisture in the operating
environment may cause damage or lead to malfunction. The UPS should be always protected from
the outside weather and sunshine. The operating environment must meet the weight, airflow, size and
clearance requirements specified in the attached "technical datasheet" of this manual or in the
technical datasheet of the same product (separate document).
Under no circumstances, the UPS should be installed in an airtight room, in the presence of
flammable gases, or in an environment, exceeding environmental requirements specified here below.
The ambient temperature for operating the UPS must be in the range 0 °C to +40 °C. The Ideal
temperature also recommended to achieve a long life of the UPS and VRLA batteries is +20°C to
+25°C. The relative humidity should be below 95% (non-condensing) and the max. altitude without
de-rating is 1000m above sea level.
2.2

CE marking and declaration of safety and EMC conformity

The product has the CE marking in compliance with the following European directives
•
Low Voltage Directive:
•
EMC Directive:
The product applies the actual UPS standards, listed in the Table 1 below.
Table 1: UPS Standards.
Description
Safety
Electromagnetic Compatibility (EMC)
2.3

Inquiries

Address inquiries about the UPS to the local office or agent certified by the supplier. Please note the
type code and the serial number – shown in the type plate of the product
equipment and contact your nearest agent certified by the supplier.
Modifications reserved
Page 9/94
2014/35/EU
2014/30/EU
Product standards
IEC/EN 62040-1
IEC/EN 62040-2
General standards
IEC/EN 60950-1
IEC/EN 61000-4-2
IEC/EN 61000-4-3
IEC/EN 61000-4-4
IEC/EN 61000-4-5
IEC/EN 61000-4-6
IEC/EN 61000-4-8
IEC/EN 61000-2-2
(see chapter 2.4) – of the