Menu List - Sony HDCU3100 Operating Instructions Manual

Menu List

Note
The following conventions are used in the menu list table.
Settings column values (e.g. ON, OFF, 0): Default settings are underlined
Execute via ENTER: Press the CONTROL knob or move the CANCEL/ENTER lever to the ENTER position to execute.
SYSTEM CONFIG menu
Note
Items marked with "a)" are not available on the HDCU3170 in triax transmission mode.
SYSTEM CONFIG
Page name Item
Page No.
<CAMERA I/F> CABLE TYPE
S01
FIBER TRANSMIT
RATE
OPTICAL SIGNAL
BARS
TEST
START UP VIDEO
SIGNAL
Set value
FIBER CAMERA CABLE, COAX,
COAX(HDCE), SINGLE-MODE
FIBER, TRIAX CAMERA CABLE
HIGH, HD, ---
a)
ON, OFF
OFF, ON
OFF, TEST1, TEST2
BARS, GRAY
21
Description
Specifies the cable type used for connecting the
camera.
FIBER CAMERA CABLE: Select when using the
HDCU3100 or when using the HDCU3170 with
HKCU-FB30 installed.
TRIAX CAMERA CABLE: Select when using the
HDCU3170.
SINGLE-MODE FIBER: Selectable only when the
HKCU-SM30 is installed.
Sets the transfer rate when an optical fiber cable is
connected.
HIGH: When the HDC3500/3100 or HDC2000 series
is connected
HD: When the HSC300RF/100RF is connected
---: When CABLE TYPE is set to COAX,
COAX(HDCE), or TRIAX CAMERA CABLE
Turns the optical signal output from the CCU to the
camera ON/OFF.
(Displayed only when connected using optical fiber
composite cable.)
Turns color bars ON/OFF.
Turns TEST SAW ON/OFF.
Selects the signal to output until the unit connects
with the camera after power-on.