Rear Panel - Sony HDCU3100 Operating Instructions Manual

Rear Panel

HDCU3100
1
qf
HDCU3170
1
qf
a AUDIO OUT CH1, CH2 (audio output 1, 2) connectors
(XLR 3-pin)
Used to output the audio signal to the AUDIO IN connectors of
the video camera.
b Rear indicator
Displays calls and statuses.
c Option kit mounting port
One of the following option kits can be attached.
• HKCU-SFP30 ST-2110 Interface Kit
• HKCU-SM30 Single Mode Fiber Connector Kit
For an overview of option kits, see "Option Kits" (page 12).
d SDI OUT (3G/HD/SD SDI output) 1/2/3/4 connectors
The signal from the video camera may be output as four 3G
SDI signals, HD SDI signals or SD SDI signals. They can
output signals with superimposed text characters and
markers.
For details on settings, contact a Sony service or sales
representative.
e NETWORK TRUNK connector (RJ-45 8-pin)
Used to connect the device connected to the NETWORK
TRUNK connector of a camera with the network connection
device.
f LAN-COM connector (RJ-45 8-pin)
Used to connect to a LAN. Connect a LAN hub (10BASE-T/
100BASE-TX), using a LAN cable (shielded type of category 5
or more).
2 3 4 5 6 7
qg qh
2 3 4 5 6 7
qg qh
8 9 0 qa
qj
8 9 0 qa
qj
g SDI RET (3G/HD/SD SDI return video input) 1/2/3/4
connectors (BNC-type)
Four different 3G/HD/SD SDI return video input signals may
be received independently. The selection of RET 1 to 4 is
made by the return switch of the video camera. The aspect
ratio can also be selected for an SD signal.
The type of input signal on RET 1 to 4 may be set individually
using the setup menu, or using the MSU-1000 series Master
Setup Unit.
For details on the setup menu, contact a Sony service or sales
representative.
Refer also to the Master Setup Unit manual.
h CHARACTER (character output) / AES/EBU connector
(BNC-type)
CHARACTER: Outputs the self-diagnostic results or setup
menu of the unit as an SD analog video signal.
AES/EBU: Outputs the AES/EBU format digital audio signal
that is input to the video camera.
i RCP/CNU connector (round 8-pin)
Used to connect to an MSU-1000 series Master Setup Unit,
CNU-700 Camera Command Network Unit, or RCP-1500/
1000 series Remote Control Panel via a CCA-5 Connection
Cable. Control signals are sent and received via this
connector. When using an RCP-1500/1000 series unit, power
is also supplied.
j TRUNK connector (round 12-pin)
Used to connect to the CCU connector on a camera via an RS-
232C or RS-422A interface. Communication with up to two
channels is available.
10
qs qd
qs qd