Sony HDCU3100 Operating Instructions Manual page 38

MAINTENANCE menu
Note
Items marked with "a)" are not available on the HDCU3170 in triax transmission mode.
MAINTENANCE
Page name Item
Page No.
<TRUNK/PROMPTER> TRUNK LINE
M01
PROMPTER
NETWORK TRUNK
HD TRUNK
HD PROMPTER
Set value
CHANNEL MODE When <CAMERA I/F> t CABLE
TYPE is FIBER CAMERA CABLE
and FIBER TRANSMIT RATE is
HIGH: 2CH(MAX 75Kbps),
1CH(MAX 150Kbps)
When <CAMERA I/F> t CABLE
TYPE is FIBER CAMERA CABLE
and FIBER TRANSMIT RATE is
HD: 1CH(MAX 38Kbps)
When <CAMERA I/F> t CABLE
TYPE is TRIAX CAMERA CABLE:
2CH(MAX 19Kbps), 1CH(MAX
38Kbps)
INTERFACE 232C, 422A
CHANNEL MODE 2CH, 1CH
a)
MODE OFF, NETWORK,
NETWORK+VIDEO
a)
DATA RATE 100Mbps, 1Gbps
CAMERA (ENABLE), (DISABLE)
(ENABLE), (DISABLE)
(ENABLE), (DISABLE)
FRAME SYNC OFF, ON, (ON)
SOURCE SDI-I/O4, IP-RET3
Description
Sets the number of channels to be used.
Sets the communication line mode.
When FIBER TRANSMIT RATE is set to HD, this is
fixed at 422A.
Sets the number of prompter lines.
Fixed to 1CH when using HDCU3170.
Note
The number of lines will vary depending on the
number of prompter lines of the connected camera.
Not displayed when using HDCU3170.
Sets the mode for the network trunk.
OFF: NETWORK TRUNK is not used.
NETWORK: NETWORK TRUNK is used (maximum
1 Gbps).
NETWORK+VIDEO: NETWORK TRUNK is used at
the same time as HD TRUNK/HD PROMPTER
(maximum 100 Mbps).
Displays the data transfer rate. (Display only)
Displays "ENABLE" or "DISABLE" for CAMERA.
(Display only)
Fixed to DISABLE when using HDCU3170.
Displays "ENABLE" or "DISABLE" for HD TRUNK.
(Display only)
Fixed to DISABLE when using HDCU3170.
Displays "ENABLE" or "DISABLE" for HD
PROMPTER. (Display only)
Fixed to DISABLE when using HDCU3170.
Turns the frame synchronizer function ON/OFF.
Sets the HD prompter signal source.
IP-RET3 is selectable only when the HKCU-SFP30
ST-2110 Interface Kit is installed.
38