Front Panel - Native Instruments Komplete Audio 6 Manual

4.1

Front Panel

The front panel of the KOMPLETE AUDIO 6.
(1) INPUT 1 and INPUT 2
use with XLR or 1/4" jack connectors. When connecting an XLR connector, an XLR lock latch-
es. You can easily release the connector by pressing the release tab.
The input GAIN knob lowers/raises the amount of signal going into the KOMPLETE AUDIO 6.
The LINE/INST toggle button selects either
thesizer or the output of an electric piano) or
or a bass guitar). XLR connected gear is not affected by this button.
(2) MONITOR section: The
tivated, the unaffected input signal will be heard with zero latency. The
bles as a monitor selector switch. When held for one second, it cycles through three monitor
modes: monitor signal to outputs
signal to both output pairs
device's top panel display which monitoring mode is currently active.
The MONO switch toggles the monitor output selection between a mono signal and a stereo
signal. Switching to a mono setting aids in monitoring a mono signal, such as a guitar's mono
input.
(Line and Microphone): These inputs have a combination socket for
LINE
INST
ON switch turns direct monitoring on/off. With direct monitoring ac-
OUT 1/2; monitor signal to outputs
OUT 1/2 and OUT 3/4. The LEDs from the
mode for strong-signaled inputs (like a syn-
for weak-signaled inputs (such as a guitar
OUT
MONITOR
KOMPLETE AUDIO 6 - Manual - 17
The Hardware in Detail
Front Panel
ON switch also dou-
3/4; and monitor
section on the