Table of Contents
Advertisement
Make sure the KOMPLETE AUDIO 6 is connected to your computer as described during the
installation chapter (chapter
puter's main audio output device (see chapter
Connecting Speakers
for instructions on how to connect speakers (active and passive) to your
KOMPLETE AUDIO 6.
To use the KOMPLETE AUDIO 6 in a setup with typical line level equipment:
1.
Turn the Volume Control knob
AUDIO 6 to the left-end stop to set the volume to minimum.
2.
Plug a pair of stereo 1/4" TRS cables from the outputs of your device into the inputs
and
IN 4
on the rear panel of the KOMPLETE AUDIO 6 or unbalanced ¼" cable if you are
using a mono device.
3.
Open the audio preferences of your audio recording software, and select the KOMPLETE
AUDIO 6 as your input and output device (you may have to restart your host software for
the changes to become active). Refer to the documentation of your audio recording soft-
ware for information on how to configure the audio device setup.
4.
Adjust the output signal of your connected device by using the relevant volume/gain con-
trol. Check the KOMPLETE AUDIO 6's input LEDs
make sure your input signal does not clip; adjust the device's output level so that the
LEDs light green on input. A red lighting LED indicates signal clipping.
5.
Gradually turn the Volume Control knob
AUDIO 6 to the right until you reach a good listening level.
↑2, Installing KOMPLETE AUDIO
↑3, Basic
(MAIN VOLUME
(MAIN VOLUME
Using the KOMPLETE AUDIO 6 (Setup Scenarios)
KOMPLETE AUDIO 6 in a Recording Setup
6), and configured as your com-
Configuration). See chapter
1/2) on the top panel of the KOMPLETE
(INPUT 3
and
4
on the top panel) to
1/2) on top of the KOMPLETE
KOMPLETE AUDIO 6 - Manual - 44
↑6.1,
IN 3
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
