Native Instruments Komplete Audio 6 Manual page 26

Digital Sync Source Section
The Digital Sync Source section in the Audio Settings page of the Control Panel.
In the Digital Sync Source
gets synchronized to the clock of an external device:
Internal (standard setting): Leave this radio button selected if you don't want the device to
▪
be synchronized to the clock of an external device.
External S/PDIF 5|6: Select this radio button if you want the device to be synchronized to
▪
the clock of another external device via S/PDIF. When switching to this setting, the device
automatically tries to establish synchronization to an external clock at the digital input/out-
put 5 and 6 (see also chapter
interface switches back to internal clock mode. If the synchronization is successful, the top
panel's Sync LED lights (see chapter
Direct Monitoring Section
The Direct Monitoring section in the Audio Settings page of the Control Panel.
In the Direct Monitoring
send the signal from the input directly to the output of the device (at zero latency).
This function can be accessed from the MONITOR section on the device's front panel
too; see chapter ↑4.1, Front Panel
The Direct Monitoring section has a button and a drop-down menu:
section, you can select whether the device uses its internal clock or
↑4.2, Rear Panel). If the synchronization request fails, the
↑4.3, Top
section, you can set the device to bypass any signal processing and
for further information.
Advanced Configuration on Windows (Control Panel)
Panel).
KOMPLETE AUDIO 6 - Manual - 26
Advanced Configuration