Native Instruments Komplete Audio 6 Manual page 40

2. Plug the XLR cable connection of your dynamic microphone into either
PUT 2 on the front panel of your KOMPLETE AUDIO 6.
3. Plug the 1/4" TRS jack of your headphones into the
AUDIO 6's front panel. Turn the Volume Control knob (VOLUME) in the headphone sec-
tion of the KOMPLETE AUDIO 6 to the left-end stop to set the volume to minimum.
4. Open the audio preferences of your audio recording software, and select KOMPLETE AU-
DIO 6 as your input and output device (you may have to restart your host software for the
changes to become active). Refer to the documentation of your audio recording software
for information on how to configure the audio device setup.
5. While singing / playing an instrument into the microphone, adjust the input signal by
turning the relevant input channel's
LEDs (INPUT 1 and
input signal does not clip; adjust the input level so that the LEDs light green on input. A
red lighting LED indicates signal clipping.
6. Gradually turn the Volume Control knob (VOLUME) in the headphone section of the KOM-
PLETE AUDIO 6 to the right until you reach a good listening level.
GAIN knob gradually to the right. Check the input
2 on the top panel of the KOMPLETE AUDIO 6) to make sure your
Using the KOMPLETE AUDIO 6 (Setup Scenarios)
KOMPLETE AUDIO 6 in a Recording Setup
INPUT 1
PHONES socket on the KOMPLETE
KOMPLETE AUDIO 6 - Manual - 40
or IN-