Configuring The User Status Display - Siemens SINUMERIK 840DE sl Commissioning Manual

10 Customer–Specific Operator Interface
10.4 User status display
10.4.1

Configuring the user status display

ShopMill on PCU 50.3
10-156
The user–specific icons are stored in folders (icoxxx) in the following three sub-
directories:
S
Manufacturer: \oem\sinumerik\hmi\ico/\coxxx
S
User: \oem\sinumerik\hmi\ico\icoxxx
The cross–channel status display is allocated and configured with user symbols
in the HEADER.INI file.
The HEADER.INI file is located in the directory F:\HMI_ADV and must be cop-
ied either to the directory F:\OEM or F:\USER.
In the section UserIcons of the HEADER.INI file, enter the names of the user
symbols and the signal for the control of the symbol selection.
Note
If you have already made these entries for HMI Advanced, you do not have to
repeat the entries for ShopMill.
[User icons]
UI_0= <Icons_00.bmp>, <Position>
UI_0:
Icons_00.bmp:
Position:
...
UI_31= <Icons_31.bmp>, <Position>
USER_ICON_BASE = DBx.DBBy
DBx.DBBy:
You will find the HEADER.INI file in the F:\HMI_ADV directory and must copy
them either to the F:\OEM or the F:\USER directory.
The user icons are addressed bit by bit, i.e. if bit n is set in signal DBx.DBBy,
then the user icon with identifier UI_n is displayed.
If the bit is reset by the PLC, the associated user icon is deleted in the program
status display.
If several user symbols are assigned to the same position, the user symbol with
the highest identifier number is displayed.
You do not need to specify blank positions.
References: /IAM/, Commissioning Manual CNC: Basic software and
HMI Advanced, SINUMERIK 840D sl/840D/840Di/810D,
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
Identifier
Name of the user icon
Position for display (1 to 16)
Signal defined by user for controlling icon
selection
IM4 Commissioning HMI Advanced
© Siemens AG 2006 All Rights Reserved
11/2006