Machine Data; Nck Machine Data For Shopmill - Siemens SINUMERIK 840DE sl Commissioning Manual

Machine Data

7.1

NCK machine data for ShopMill

© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
The startup of NCK requires that all relevant NCK machine data (including the
tool management) are set with the ShopMill–specific values.
In the operating area "Tools – zero" open the mask "Machine data" by pressing
the softkey "Machine data" in the extended softkey bar. All required machine
data for ShopMill are displayed here with information about setpoints and actual
values.
Correctly set machine data is marked with a tick. Machine data marked with an
exclamation mark must be corrected accordingly. A red exclamation mark in the
header (no., MD, target, actual) already points out to you that machine data
must be corrected.
The following signs show the rule for setpoint to actual value:
S
+: must be exact
S
v: must be at least
S
&: certain bits must be exact
If no rule is indicated for setpoint to actual value, it is only a suggestion.
NCK machine data with exact values must be set as specified. NCK machine
data with minimum values can be adapted to the specific features of your
machine.
The activation mode for each item of machine data is indicated in the column
after the actual value display.
S
po: Power On (softkey "NCK reset")
S
cf: Configuration (softkey "Set MD effective")
S
so: Immediately (no action required)
S
re: Reset ("Reset" key on machine control panel)
7
7-39