Shopmill Installation On Ncu (Hmi Embedded); Installing Shopmill On Pcu 50.3 - Siemens SINUMERIK 840DE sl Commissioning Manual

11/2006
4.2.2

ShopMill installation on NCU (HMI Embedded)

4.2.3

Installing ShopMill on PCU 50.3

© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
The complete software is pre–installed on the CompactFlash card for the oper-
ation of ShopMill on NCU (HMI Embedded). Only adaptations of the NCK and
PLC remain to be carried out.
Note
ShopMill uses the alarm texts and PLC messages of the CNC ISO
operator interface. You can find detailed information on this subject as well as
the the software installation in the following document:
References: /IHE/, Commissioning Manual CNC: Basic software and
HMI Embedded, SINUMERIK 840D sl,
If you want to install ShopMill on the PCU 50.3, the HMI Advanced software
must already be installed on the PCU 50.3.
After installation, the internal HMI Embedded on the NCU must be deactivated.
It is deactivated or activated by means of the service program Win SCP.
Start WinSCP and select "Open Terminal" under Commands.
The "sc disable hmi" action deactivates the internal HMI Embedded.
The "sc enable hmi" action activates the internal HMI Embedded.
References: /IDsl/, Commissioning Manual CNC: NCK, PLC,
drives, SINUMERIK 840D sl
/IHE/, Commissioning Manual CNC: Basic software and
HMI Embedded, SINUMERIK 840D sl,
You can install ShopMill on the PCU 50.3 in one of three different ways:
S
Installation via a network link
S
Installation from data media (e.g. CD)
S
Installation Via USB interface
Windows XP is required.
Note
ShopMill uses the alarm texts and PLC messages of the CNC ISO
operator interface. You can find detailed information on this subject as well as
the the software installation in the following document:
References: //IAM/, Commissioning Manual CNC: HMI and
/HMI Advanced,SINUMERIK 840 sl/840D/840Di/810D,
IM2 Commissioning HMI Embedded
IM7 Commissioning Operating System NCU sl
IM4 Commissioning HMI Advanced
4 Commissioning
4.2 Initial start–up
4-21