Define Texts - Siemens SINUMERIK 840DE sl Commissioning Manual

11/2006
8.10.7

Define texts

© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopMill – 11/2006 Edition
Texts (softkey name and list header for additional lists, column headers, and
cursor texts for user–defined parameters) are assigned to specific text numbers
in a text file.
These are subject to the following syntax:
Text number 0 0 "Text"
The two parameters 2 and 3 separated by blanks are control characters for text
output and must always be set to 0.
The column header in the parameter name can consist of three lines, each line
with its own text number; (see Table 8-10).
Table 8-10 Text assignment
Text type
3rd horizontal softkey
List header
Column header parameter TPC1
Cursor text parameter TPC1
Column header parameter TPC2
Cursor text parameter TPC2
Column header parameter TPC3
Cursor text parameter TPC3
Column header parameter TPC4
Cursor text parameter TPC4
Column header parameter TPC5
Cursor text parameter TPC5
Column header parameter TPC6
Cursor text parameter TPC6
Column header parameter TPC7
Cursor text parameter TPC7
Column header parameter TPC8
Cursor text parameter TPC8
Column header parameter TPC9
Cursor text parameter TPC9
Column header parameter TPC10
Cursor text parameter TPC10
Example:
89924 0 0 "Tool data"
The texts must not exceed the following number of characters:
Softkey: 6
List header: 20
Column header parameter: 7 (dependent on the column width)
Cursor text parameters: 45
8 Tool Management
8.10 Configuring the operator interface
Text number
89923
89924
89925, 89926, 89927
89931
89928, 89929, 89930
89932
89953, 89954, 89955
89965
89937, 89938, 89939
89949
89940, 89941, 89942
89950
89943, 89944, 89945
89951
89956, 89957, 89958
89966
89946, 89947, 89948
89952
89959, 89960, 89961
89967
89962, 89963, 89964
89968
8-119