Table of Contents
Advertisement
FOR CANADIAN USERS
INDUSTRY CANADA NOTICE
The Load Number of this modem is 3.
The standard connecting arrangement code for this equipment as specified in CP-01, Section 1.8.3 is
CA11A.
The Load Number assigned to each terminal device denotes the percentage of the total load to be connected
to a telephone loop that is used by the device to prevent overloading. The termination on a loop may consist
of any combination of devices subject only to the requirement that the total of the load numbers of all devices
does not exceed 100.
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus
as set out in the interference-causing equipment standard entitled "Digital Apparatus", ICES-003 of the
Industry Canada.
Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux appareils numériques
de Classe B prescrites dans la norme sur le matériel brouilleur: "Appareils Numeriques", NMB-003 édictée
par le ministre des Communications.
The Industry Canada label identifies certified equipment. This certification means that the equipment meets
certain telecommunications network protective operational and safety requirements. Industry Canada does
not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities
of the local telecommunications company. The equipment must also be installed using an acceptable method
of connection. In some cases, the company's inside wiring associated with a single line individual service
may be extended by means of a certified connector assembly (telephone extension cord). The customer
should be aware that compliance with the above conditions may not prevent degradation of service in some
situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated
by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions,
may give the telecommunications company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power utility,
telephone lines and internal metallic water pipe system, if present, are connected together. This precaution
may be particularly important in rural areas.
CAUTION: Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or electrician, as appropriate.
Advertisement
Table of Contents
