Operation
4.8 Winding the hook thread
The separate winder allows the hook thread to be wound while sewing or
independently of sewing.
Fig. 11: Winding the hook thread
(1) - Thread guide plate
(2) - Thread guide channel
(3) - Winding tensioner
To wind the hook thread:
1. Place the thread reel on the thread reel holder and guide the needle
Important: The thread guide must be parallel to the thread stand.
2. Insert the thread in a wavelike manner through the two rear holes of
3. Feed the thread from top to bottom through the thread guide
4. Guide the thread counterclockwise around the winding tensioner (3).
5. Insert the thread in a wavelike manner through the two remaining free
6. Guide the thread to the winder and clamp it behind the cutter (6).
7. Plug an empty bobbin on the winding shaft (5) and turn clockwise until
Operating Instructions 911-210 - 04.0 - 11/2016
①
②
③
thread through the hole in the guide on the thread guide.
the thread guide plate (1): From top to bottom through the rear hole
and from bottom to top through the left hole.
channel (2).
holes of the thread guide plate (1): From bottom to top through the rear
hole and from top to bottom through the front hole.
Tear off the thread, making sure that the thread is NOT under tension.
it clicks into place.
(4) - Bobbin winder flap
(5) - Bobbin shaft
(6) - Cutter
⑥
⑤
④
25