Table of Contents
Advertisement
Programming
Operating Instructions 911-210 - 04.0 - 11/2016
Symbol
Meaning
Optional equipment
Reduced clamp pressure:
Optional equipment limiting the amount of clamp pressure to allow for
better alignment on insertion.
Neat seam beginning:
Optional equipment, activates stitch position optimization ( Additional
Instructions Stitch Position Optimization)
Marking lamps:
Optional equipment providing orientation lines on insertion for easier
alignment. Up to 4 marking lamps can be switched on for each program.
This setting only activates the option; the actual switching is defined in the
program parameters (see Marking lamps ( p. 64))
Barcode scanner:
Optional equipment for performing a safety check before sewing.
A barcode can be stored with each program. Agreement with the barcode
on the clamp is checked. Sewing only proceeds when the barcodes agree.
You enter the barcode ID in the program parameters (see Clamp ID code
( p. 63)).
Clamp type
The following clamp types are available:
Single clamp: One-piece parallel clamp with angle mount
Single clamp with hanger (Def.): One-piece parallel clamp with hanger
mount
Double clamp: Two-piece parallel clamp with angle mount
Alternating clamp: Removable clamp
Special clamp: Special clamp
Clamp limits
Standard limits (Def.)
No additional structures are taken into account.
Special limits
Individual limits are taken into account.
Pedal mode
The following options are available:
Mode 1: The current position of the pedal is evaluated.
Mode 2 (Def.): The pedal must be returned to the initial position after every
actuation before a new actuation is recognized.
Mode 3: The current position of the pedal is evaluated.
The quick-start mode is also enabled (see Insertion mode ( p. 64)).
The machine must be switched off and on in order to activate the quick-
start mode.
Push button: In push button mode one sensor is used only for controlling
the clamp motion (up and down). The other sensor is used for starting the
sewing process.
Barcode mode
The following options are available:
Manual: Machine checks whether the inserted clamp matches the entered
seam program. If the clamp is correct, the machine is ready for sewing.
If the clamp is incorrect, an error message will be displayed, and the clamp
will have to be replaced.
Automatic: The machine looks for the seam program that matches the
inserted clamp. The machine is ready for sewing once the seam program
has been selected.
69
Advertisement
Table of Contents
