Operation
Fig. 13: Changing the bobbin (2)
(4) - Bobbin
(5) - Bobbin case retainer
(6) - Guide
3. Swivel up the bobbin case retainer (5).
4. Remove the empty bobbin.
5. Insert a full bobbin.
Important: Insert the bobbin (4) so that it moves in the opposite direction
of the hook when the thread is pulled out.
6. Feed the hook thread through the slot (8) in the bobbin case.
7. Pull the hook thread under the tension spring (7).
8. Feed the hook thread through the guide (6) and pull it approx. 3 cm
9. Hold the hook thread in place and close the bobbin case retainer (5).
10. Cut off the surplus thread above the cover plate
11. Release the threading mode (2) button.
The cover plate (3) pivots back to the original position.
Accounting for a bobbin change in the seam program
The method of accounting for a bobbin change in the seam program is de-
scribed in the chapter Changing the bobbin ( p. 45).
Operating Instructions 911-210 - 04.0 - 11/2016
④
⑤
⑥
⑦
further until reaching the bobbin cover.
⑧
(7) - Tension spring
(8) - Slot
27