Power Source Management By Remote Control; Reset (Load Factory Settings) - Weco WF-104 Instruction Manual

WF-104
WF-108

4.1 POWER SOURCE MANAGEMENT BY REMOTE CONTROL

Hold down the button for 3 seconds. [
POWER SOURCE USER INTERFACE]
The following LED illuminates on the power source panel:
The following message appears on the power source displays: - - -
The power source is managed by the remote control connected to it.
The welding power source sets up for welding.
First power-up or power-ups following a RESET procedure
The welding power source sets up for welding with the factory preset values..
Subsequent power-ups
The welding power source sets up for welding in the latest stable welding configuration that was
active at the time of power-off.
During power-up all functions are inhibited and the following displays remain blank: D1, D2, D3
D4: The following messages will appear in sequence on this display:
Tab. 1- Messages at power-up
WF-104/WF-108
FW: XX.XX.XXX
PROGRAM UPDATE
POWER PULSE ZZZ
FW: YY.YY.YYY
WELDING MACHINE OK
If communication with the IR (robot interface) board has been enabled, the following additional messa-
ges will appear:
IRxx - Modbus
FW: XX.XX.XXX
IR UPDATE
5

RESET (LOAD FACTORY SETTINGS)

To perform a reset the power source must be managed via the remote control.
The reset procedure involves complete restoration of the default values, parameters and memory set-
tings set in the factory.
The reset procedure is useful in the following cases:
- Too many changes made to the welding parameters so user finds it difficult to restore defaults.
- Unidentified software problems that prevent the welding power source from functioning correctly.
WELD THE WORLD
OPERATION TO BE PERFORMED ON THE
XX.XX.XXX= wire feeder software version.
The welding power source is synchronising the wire feeder and
power source software.
ZZZ= Ampere value of the power source.
YY.YY.YYY= power source software version.
XX.XX.XXX= software version.
The welding unit is synchronising the wire feeder software with
the robot interface one.
This message appears every time a synchronisation occurs.
Cod. 006.0001.0940
16/04/2018 V.2.25
ENGLISH
17