Selecting Jobs Using The Torch Buttons - Weco WF-104 Instruction Manual

C . 006.0001.0940
od
16/04/2018 V.2.25
ENGLISH
Tab. 14 - JOB importing operation messages
MESSAGE
USB DEVICE NOT FOUND
FILE NOT FOUND
IMPORT FAILED
IMPORT IN PROGRESS
IMPORT COMPLETE

11.8 SELECTING JOBS USING THE TORCH BUTTONS

When an UP/DOWN torch is installed, JOBs can be selected in a JOB sequence using the buttons on
the welding torch.
JOBs can be scrolled only when the welding operation is not being carried out.
During the welding operation (with an active JOB) the parameter values displayed can be temporarily
changed with the UP/DOWN keys; at the end of the welding operation, the original values are restored.
When a DIGIMANAGER torch is installed the operations described above can be carried out, with the
following differences:
- a job can be loaded directly from the torch
- jobs can be scrolled regardless of the sequence they belong to.
Sequence 1
J.01 J.02 J.03
Select and upload one of the JOBs belonging to the desired sequence (e.g. J.06) through the power
source user interface.
Use the torch buttons to scroll through the JOBs of sequence 2 (J.05, J.06, J.07).
64
WELD THE WORLD
MEANING
USB device not found
File not found
Importing procedure
failed.
The JOBs saved on the
USB memory stick are
being imported
Importing procedure
completed
Sequence 2
JOB not
saved
J.05 J.06
CHECKS
- incorrectly inserted memory stick
- memory stick removed before completing
the operation.
- there are no JOBs loaded onto the USB
memory stick.
- USB not formatted as FAT32.
- unidentifiable generic error: re-insert the
memory stick and retry.
- the connected USB drive is damaged.
JOB not
saved
J.07 J.09
WF-104
WF-108
Sequence 3
J.10 J.11