Table of Contents
Advertisement
SCSI Commands
Completion Status
Code
Message
Description
♦ The tape is positioned to the logical block address specified.
00h
Good
♦ The drive remains in any previously set mode.
Status
♦ The drive is ready to perform any appropriate command.
Note: If Immed is 1, then Good Status only indicates that the command is
valid.
02h
Check
Use the Request Sense command to retrieve status information. Possible
Condition
Sense Keys are:
Code
02h
04h
05h
06h
08h
Message
Description
Not Ready
No cartridge is in the drive.
Hardware Error
Parity error on SCSI bus or drive hardware fail-
ure detected.
Illegal Request
The Command Descriptor Block is invalid.
Unit Attention
The cartridge was changed, or the drive was
reset prior to this command.
Blank Check
The drive encountered EOD.
Page 37
Advertisement
Table of Contents
