Table of Contents
Advertisement
Page 126
Completion Status
Code
Message
Description
• The filemarks have been sent to the buffer.
00h
Good
Status
• The drive remains in any previously set mode.
Note: If Immed is 1, then Good Status only indicates that the command is
valid.
02h
Check
Use the Request Sense command to retrieve status information. Possible
Condition
Sense Keys are:
Code
02h
03h
04h
05h
06h
07h
0Dh
Message
Description
Not Ready
No cartridge is in the drive.
Media Error
Unrecoverable data error encountered.
Hardware Error
Parity error on the SCSI bus or drive hardware
failure.
Illegal Request
The Command Descriptor Block is invalid.
Unit Attention
The cartridge was changed, or the drive was
reset prior to this command.
Write Protect
The tape is write-protected; check the cartridge
before continuing.
Volume
The command completed with Overflow data in
the buffer because EOT was encountered.
LTO SCSI Interface Manual
Advertisement
Table of Contents
