Table of Contents
Advertisement
SCSI Commands
Completion Status
The Set Capacity command sets the available tape capacity to:
Tape Capacity = Total Tape Capacity × Capacity Proportion Value / 65535
Code
Message
Description
♦ The drive is ready to perform any appropriate command.
00h
Good
♦ The drive remains in any previously set mode.
Status
♦ The tape position is at BOT.
♦ Data on tape is logically inaccessible.
Note: If Immed is 1, then Good Status only indicates that the command is
valid.
02h
Check
Use the Request Sense command to retrieve status information. Possible
Condition
Sense Keys are:
Code
01h
02h
04h
05h
06h
07h
Message
Description
Recovered Error
Tape capacity is rounded up to 10% of total
capacity.
Not Ready
No cartridge is in the drive.
Hardware Error
Drive hardware failure detected.
Illegal Request
The tape is not at BOT or the Command De-
scriptor Block is not valid.
Unit Attention
The cartridge was changed or the drive was
reset prior to this command.
Write Protected
The cartridge is write-protected.
Page 113
Advertisement
Table of Contents
