Page 1
Laptop SSHD SATA Product Manual Standard models Self-Encrypting Drive models ST1000LM014 ST1000LM015 ST1000LX000 ST1000LX001 SED (FIPS 140-2) models ST750LM000 ST1000LM028 100716627, Rev. M December 2016...
Page 2
Seagate, Seagate Technology and the Spiral logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. 3D Defense System and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. The FIPS logo is a certification mark of NIST, which does not imply product endorsement by NIST, the U.S., or Canadian governments.
For information regarding online support and services, visit: http://www.seagate.com/contacts/ For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: http://www.seagate.com/services-software/data-recovery-services/ For Seagate OEM, Distribution partner and reseller portals, visit: http://www.seagate.com/partners/ Seagate Laptop SSHD SATA Product Manual, Rev. M...
Introduction Introduction ® This manual describes the functional, mechanical and interface specifications for the following Seagate Laptop SSHD model drives: Standard models Standard SED models SED (FIPS 140-2) models ST1000LX000 ST1000LM014 ST1000LM015 ST1000LM028 ST1000LX001 ST750LM000 Previous generations of Seagate Self-Encrypting Drive models were called...
Introduction Seagate Laptop SSHD Self-Encrypting Drive models have the following additional features 16 independent data bands Authenticated firmware download. Automatic data encryption/decryption Controlled access Cryptographic erase of user data for a drive that will be repurposed or scrapped Drive locking Random number generator There is no significant performance difference between Self-Encrypting Drive and standard (non-Self-Encrypting Drive) models.
0° to 60°C Nonoperating temperature –40° to 70°C (Ambient) 20°C per hour max (operating) Temperature gradient (max) 35°C per hour max (nonoperating) 5% to 95% (operating) Relative humidity 5% to 95% (nonoperating) Seagate Laptop SSHD SATA Product Manual, Rev. M...
Page 10
Supports Hotplug operation per the Serial ATA Revision 3.2 specification One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. Seagate Laptop SSHD SATA Product Manual, Rev. M...
Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in a random track location. Standby mode During standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/write electronics are in power-down mode. Seagate Laptop SSHD SATA Product Manual, Rev. M...
Page 13
Standby power is measured at steady state (after 200ms from transition) 2.7.1.1 Typical current profiles The typical 5V startup and operation current profile is shown in Figure Figure 1 Typical 5V Startup and Operation Current Profile Seagate Laptop SSHD SATA Product Manual, Rev. M...
If the standby timer reaches zero before any drive activity is required, the drive makes a transition to standby mode. In both Idle and standby mode, the drive accepts all commands and returns to active mode when disk access is necessary. Seagate Laptop SSHD SATA Product Manual, Rev. M...
Environmental Specifications This section provides the temperature, humidity, shock, and vibration specifications for Seagate Laptop SSHD drives. Ambient temperature is defined as the temperature of the environment immediately surrounding the drive. Above 1000 feet (305 meters), the maximum temperature is derated linearly by 1°C every 1000 feet.
Test for prominent discrete tones (PDTs) Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses the lower limit for the threshold curve* to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards.
From this page, click on the “Is my Drive under Warranty” link. Users will be asked to provide the drive serial number, model number (or part number) and country of purchase. The system will display the warranty information for the drive. Seagate Laptop SSHD SATA Product Manual, Rev. M...
EN 55022, Class B and the immunity levels are defined by EN 55024. Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if necessary) and terminators on all unused I/O ports.
Users should use caution exposing any electronic components to uncontrolled chemical pollutants and corrosive chemicals as electronic drive component reliability can be affected by the installation environment. The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%.
Signal cable Power cable Each cable is keyed to ensure correct orientation. Seagate Laptop SSHD SATA drives support latching SATA connectors. Drive Mounting Users can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes. Refer to Figure 3 for drive mounting dimensions.
Page 21
3.567 in 90.602 mm 0.551 in 13.995 mm 0.370 ± .008 in 9.50 ± 0.20 mm 3.567 in 90.602 mm 0.551 in 13.995 mm 2.430 in 61.722 mm 0.160 in 4.064 mm Seagate Laptop SSHD SATA Product Manual, Rev. M...
Figure 4 Example of FIPS tamper evidence labels. For reference only. May not represent actual drive. Note Seagate Laptop SSHD SATA Product Manual, Rev. M...
The Trusted Computing Group (TCG) is an organization sponsored and operated by companies in the computer, storage and digital communications industry. Seagate's SED models comply with the standards published by the TCG. To use the security features in the drive, the host must be capable of constructing and issuing the following two SATA commands:...
In addition to providing a locking mechanism to prevent unwanted firmware download attempts, the drive also only accepts download files which have been cryptographically signed by the appropriate Seagate Design Center. Three conditions must be met before the drive will allow the download operation: 1.
Hot-Plug Compatibility Seagate Laptop SSHD SATA drives incorporate connectors which enable users to hot plug these drives in accordance with the Serial ATA: High Speed Serialized AT Attachment specification revision 2.0. This specification can be downloaded from www.serialata.org. This device requires a COMRESET from the host after a hotplug event.
Set Max Features Password: register as defined to the right. Lock: Unlock: Freeze Lock: Set Max Address Ext Set Multiple Mode S.M.A.R.T. Disable Operations B0h/D9h S.M.A.R.T. Enable/Disable Autosave B0h/D2h Seagate Laptop SSHD SATA Product Manual, Rev. M...
Number of current logical heads xxxx Number of current logical sectors per logical track xxxx 57–58 Current capacity in sectors xxxx Number of sectors transferred during a xxxx Read Multiple or Write Multiple command Seagate Laptop SSHD SATA Product Manual, Rev. M...
Page 29
Hardware reset value (see description following this table) xxxx Auto acoustic management setting xxxx Stream Min. Request Size 0000 Streaming Transfer Time - DMA 0000 Streaming Access Latency - DMA and PIO 0000 Seagate Laptop SSHD SATA Product Manual, Rev. M...
Page 30
160–221 ATA-reserved 0000 Transport major version number 101F 223–254 ATA-reserved 0000 Integrity word xxA5 See the bit descriptions below for words 63, 88 and 93 of the Identify Drive data. Note Seagate Laptop SSHD SATA Product Manual, Rev. M...
Page 31
Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Word 93 1 = 80-conductor cable detected, CBLID above VIH 0 = 40-conductor cable detected, CBLID below VIL Seagate Laptop SSHD SATA Product Manual, Rev. M...
Disable the Free Fall Protection feature (41 above enables the Free Fall Protection feature) Report full capacity available At power-on, or after a hardware or software reset, the default values of the features are as indicated above Note Seagate Laptop SSHD SATA Product Manual, Rev. M...
S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x 04 (abort) is written to the Error register. Seagate Laptop SSHD SATA Product Manual, Rev. M...
Page 34
ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100716627, Rev. M...