Height; Right Angle - Canon DADF-M1 Service Manual

Chapter 4
[1]
[2]
[3]
F-4-33

4.3.1.6 Height

1) With the machine closed, check to see if the height
adjusting rolls [1] found at the left rear and front are
in contact with the reading glass [2].
[1]
[2]
F-4-34
Memo:
To facilitate the work, try executing the following to
turn on the scanning lamp using the host machine's
service mode: COPIER>FUNCTION>MISC-
4-22
[4]
0003-1849
R>SCANLAMP.
<If Not in Contact>
If the height adjusting rolls [1] at the left front and
rear are not in contact with the reading glass [2],turn
the fixing screw [3] found at the top of the left hinge.
[3]
F-4-35

4.3.1.7 Right Angle

The following steps adjust the relationship between
the machine's original feed direction and the host
machine's scanner system:
1) Place the Test Chart in the machine, and make a
copy.
2) Check the right angle of the image in relation to the
leading edge of the output (i.e., angle A).
F-4-36
3) Loosen the 2 knurled screws found at the front of
the right hinge unit.
4) Bend over the edge of the rubber cover [2] found at
0003-2252
[A]