Table of Contents
Advertisement
Mud Ring Installation
Backing Clip
Mounting Screw
Rotate the backing clip
out of the way to insert
the mud ring into the wall.
Figure 2.
1.
Place 1.25 inches (3.18 cm) long or 0.75 inch (1.90 cm) #6-32 thread machine screws
through the large holes in the two corners of the mounting bracket. Use the shortest
possible screw needed.
2.
Loosely fasten the mounting backing clip on the end of each screw.
3.
Insert the mounting bracket into the opening in the wall (see
Preparation
4.
Rotate each backing clip so that the tab is behind the installation surface to hold the
bracket snuggly in place when the screw is tightened.
NOTE: The backing clip can be installed as shown in Layout A or Layout B (see
figure 3).
Mounting Surface
Backing Clip
0.75" #6-32 Screw
Figure 3.
5.
Use a cross-head (Phillips) screwdriver to fasten the screws and backing clips in place.
Installing the Mud Ring with Backing Clips
on the previous page).
Mounting Surface
Backing Clip
1.25" #6-32 Screw
Layout A
Backing Clip Installation
XTP R HWP 201 Wallplate Receiver • Installation
Mounting Surface
Layout B
6
Advertisement
Table of Contents
