Sample Programs - Rabbit RabbitCore RCM5400W User Manual

C-programmable wi-fi core module

Table of Contents

3.2 Sample Programs

Of the many sample programs included with Dynamic C, several are specific to the

RCM5400W modules. These programs will be found in the

—Demonstrates use of the digital outputs by having you turn LEDs

•

CONTROLLED.C

DS2 and DS3 on the Prototyping Board on or off from the

Parallel Port B bit 2 = LED DS2

Parallel Port B bit 3 = LED DS3

Once you compile and run

Dynamic C

STDIO

Press "2" or "3" on your keyboard to select LED DS2 or DS3 on the Prototyping

Board. Then follow the prompt in the Dynamic C

or OFF. A logic low will light up the LED you selected.

—demonstrates the use of assembly language to flash LEDs DS2 and

•

FLASHLED1.C

DS3 on the Prototyping Board at different rates. Once you have compiled and run this

program, LEDs DS2 and DS3 will flash on/off at different rates.

—demonstrates the use of cofunctions and costatements to flash LEDs

•

FLASHLED2.C

DS2 and DS3 on the Prototyping Board at different rates. Once you have compiled and

run this program, LEDs DS2 and DS3 will flash on/off at different rates.

CONTROLLED.C

window.

SAMPLES\RCM5400W

STDIO

, the following display will appear in the

window to turn the LED ON

STDIO

folder.

window on your PC.

RabbitCore RCM5400W

Table of Contents

Do you have a question about the RabbitCore RCM5400W and is the answer not in the manual?