Running Wi-Fi Sample Programs - Rabbit RabbitCore RCM5400W User Manual

6.2 Running Wi-Fi Sample Programs

In order to run the sample programs discussed in this chapter and elsewhere in this manual,
1. Your module must be plugged in to the Prototyping Board as described in Chapter 2,
"Getting Started."
2. Dynamic C must be installed and running on your PC.
3. The programming cable must connect the programming header on the module to your PC.
4. Power must be applied to the module through the Prototyping Board.
Refer to Chapter 2, "Getting Started," if you need further information on these steps.
To run a sample program, open it with the menu, then compile and run it by pressing .
File F9
Each sample program has comments that describe the purpose and function of the pro-
gram. Follow the instructions at the beginning of the sample program.
Complete information on Dynamic C is provided in the Dynamic C User's Manual.
User's Manual 57