Rabbit RabbitCore RCM5400W User Manual page 93

Table A-6 lists the delays in gross memory access time for several values of VDD
Table A-6. Preliminary Data and Clock Delays
Clock to Address
Output Delay
VDD
(ns)
IO
(V)
30 pF 60 pF 90 pF
3.3 6
1.8 18
The measurements are taken at the 50% points under the following conditions.
• T = -20°C to 85°C, V = VDD
• Internal clock to nonloaded CLK pin delay ≤ 1 ns @ 85°C/3.0 V
The clock to address output delays are similar, and apply to the following delays.
• T , the clock to address delay
adr
• T , the clock to memory chip select delay
CSx
• T , the clock to I/O chip select delay
IOCSx
• T , the clock to I/O read strobe delay
IORD
• T , the clock to I/O write strobe delay
IOWR
• T , the clock to I/O buffer enable delay
BUFEN
The data setup time delays are similar for both T
When the spectrum spreader is enabled with the clock doubler, every other clock cycle is
shortened (sometimes lengthened) by a maximum amount given in the table above. The
shortening takes place by shortening the high part of the clock. If the doubler is not
enabled, then every clock is shortened during the low part of the clock period. The maxi-
mum shortening for a pair of clocks combined is shown in the table.
Rabbit Semiconductor's Technical Note TN227, Interfacing External I/O with Rabbit
Microprocessor Designs
tions for interfacing I/O devices to the Rabbit 5000 microprocessors.
OEM User's Manual
Data Setup
Time Delay
(ns)
8 11 1
24 33 3
±10%
IO
, which is included with the online documentation
Worst-Case
Spectrum Spreader Delay
(ns)
0.5 ns setting 1 ns setting
no dbl / dbl no dbl / dbl
2.3 / 2.3 3 / 4.5
7 / 6.5 8 / 12
and T .
setup hold
.
IO
2 ns setting
no dbl / dbl
4.5 / 9
11 / 22
, contains sugges-
87