Table of Contents
Advertisement
2.3 Run a Sample Program
If you already have Dynamic C installed, you are now ready to test your programming
connections by running a sample program. Start Dynamic C by double-clicking on the
Dynamic C icon on your desktop or in your
on the "Compiler" tab in the Dynamic C
on the "Communications" tab and verify that
support the USB programming cable. Click
You may have to select the COM port assigned to the USB programming cable on your
PC. In Dynamic C, select
"Communications" tab, then click
Enter
on your computer keyboard if the COM port number is outside the range on the
dropdown menu.
Now find the WIFISCAN.C sample program in the Dynamic C Samples\WiFi folder,
open it with the File menu, then compile and run the sample program by pressing F9.
The Dynamic C
STDIO
of access points/ad-hoc hosts as shown here.
The following fields are shown in the Dynamic C
• Channel—the channel the access point is on (1–11).
• Signal—the signal strength of the access point.
• MAC—the hardware (MAC) address of access point.
• Access Point SSID—the SSID the access point is using.
OEM User's Manual
Start
Options > Project Options
OK
Options > Project Options
OK
. You may type the COM port number followed by
window will display
Starting scan....
menu. Select
Store Program in Flash
Use USB to Serial Converter
.
, then select this COM port on the
STDIO
window.
menu. Then click
is selected to
, and will display a list
15
Advertisement
Table of Contents
