Standalone Operation Of The Rcm5400W - Rabbit RabbitCore RCM5400W User Manual

C-programmable wi-fi core module

Table of Contents

A program "runs" in either mode, but can only be downloaded and debugged when the

RCM5400W is in the Program Mode.

Refer to the

Rabbit 5000 Microprocessor User's Manual

gramming port.

4.4.2 Standalone Operation of the RCM5400W

Once the RCM5400W has been programmed successfully, remove the programming cable

from the programming connector and reset the RCM5400W. The RCM5400W may be

reset by cycling the power off/on or by pressing the

Board. The RCM5400W module may now be removed from the Prototyping Board for

end-use installation.

CAUTION: Power to the Prototyping Board or other boards should be disconnected

when removing or installing your RCM5400W module to protect against inadvertent

shorts across the pins or damage to the RCM5400W if the pins are not plugged in cor-

rectly. Do not reapply power until you have verified that the RCM5400W module is

plugged in correctly.

OEM User's Manual

for more information on the pro-

button on the Prototyping

RESET

Table of Contents

Do you have a question about the RabbitCore RCM5400W and is the answer not in the manual?