Keypad Use - gefran GFW ADV Configuration Manual

This charter describes the optional GFW-OP keypad and use mode to display and program parameters.
Membrane keyboard
The following table describes the keypad and its functions:
Symble Reference
ESC Escape
SAVE
FIND
RST
CUST
DISP
E Enter
^ Up
v Down
< Left
> Right
Leds meaning:
LEDs Colour
BRK Yellow
CNT Yellow
EN Green
ILIM Red
N=0 Yellow
AL Red
92

KEyPAD USE

 Signal led

Liquid crystal display
5 alphameric lines of
21 characters each
 Pad keypad
Description
The program keypad is used to display the state and diagnostic parameters
during operating period; on the back is present a magnetic material strip to fix
it on GFW-master frontal or on a metal surface (ex. Electrical panel door). The keypad
is equipped with a connection cable of 70 centimeters.
Description
Comes back to the higher menu or submenu. Exits from a parameter, or a parameter list. Allows to
exit from a message requiring its use.
No function
No function
No function
No function
No function
Enters the submenu or the selected parameter, or selects an operation. It is used during the
parameter change to confirm the new set value.
Moves the selection in a menu or a parameter list highwards. During a parameter change, increases
the figure value under the cursor.
Moves the selection in a menu or a parameter list downwards. During a parameter change,
decreases the figure value under the cursor.
Comes back to top menu. During a parameter change, moves the cursor verso rightwards.
Enters the submenu or the selected parameter. During a parameter change, moves the cursor verso
rightwards.
Led meaning
Led is on when GFW is OFF software
Led is on when GFW is in manual operating
Led is on when during power supply
This led flashes when GFW reaches a current limit condition (if enabled).
During normal operation this led is off.
Led is on when during softstart ramp
Led is on when GFW signals an alarm trigger
80963B_MSW_GFW_11-2012_ENG